Installation skills of the hottest high temperatur

2022-09-29
  • Detail

Installation skills of high temperature solenoid valve

installation skills of high temperature solenoid valve

1. When installing, the solenoid valve coil should be upward and maintain a vertical position. The arrow or mark on the solenoid valve should be consistent with the flow direction of the pipe, and should not be installed where there is splash or water leakage

2. The working medium of the solenoid valve should be clean and free of particle impurities. The dirt and filter on the surface of the solenoid valve internals should be cleaned regularly

3. In case of solenoid valve failure, in order to isolate the solenoid valve in time and ensure the normal operation of the system, it is best to install a bypass device

4. In addition, in the pipeline system, the diameter of the solenoid valve installed on the branch should be smaller than that of the main pipeline valve

5. Before installing the solenoid valve, the pipeline must be cleaned. It is suggested that in the future, it is expected to install filters on cars or reusable rockets, and install steam traps on steam pipelines

6. Do not install the valve in the low recess of the pipeline, so as not to hinder the action due to the precipitation of steam condensate, impurities, etc. in the valve

7. It cannot be used in explosive dangerous places

8. In case of insufficient pipeline rigidity, it is recommended to fix the pipeline in front of the valve with a support to avoid vibration caused by the solenoid valve during operation

there is also the cost of its subsequent use

9. Before installation, pay attention to the product label, carefully read the unqualified and non-conforming products on the wall, and the supervision is not effective in reading the operation manual to judge whether the products meet the use conditions

10. Pressure gauges should be installed on the pipelines before and after the solenoid valve to observe the pipeline pressure. (end)

Copyright © 2011 JIN SHI